Back Probe TP-BP100-Yellow

Feature

The Back Probe TP-BP100 is very useful in back probing connectors to measure in an existing circuit without having to use a break out box or damage the wire isolation. The long, thin and flexible pins can easily be slid between the connector housing and the contacts in the connector.

Figure 1 shows the Back Probe TP-BP100 in use on a sensor measurement and figure 2 shows the Back Probe TP-BP100 in use with the Handyscope HS6 DIFF and Measure lead TP-C812B.

Back probes in use on a sensor measurement.

Figure 1: Back probes in use on a sensor measurement.

Figure 2: Back probes in use with scope and measure leads.

The Back Probe TP-BP100 is a thin and flexible back probe. The back probe can be used on any measuring lead with 4 mm banana plugs.

The Back Probe TP-BP100 features a collar that improves holding grip on the back probe and avoids fingers to slide to the tip where dangerous voltages may be present. The collar has one flat side, to avoid the probe rolling of a tilted surface. The long, thin and flexible tip makes it possible to connect to hard to reach places.

The Back Probe TP-BP100 – Set of 8: Green, Blue, Yellow, Red, 4 Black comes in a set containing 8 back probes, a green one, a blue one, a yellow one, a red one and four black ones. Back probes can also be ordered individually.

Specifications

The table below shows detailed specifications of the Back Probe TP-BP100.

Each back probe
Connector	4 mm banana socket
Rated voltage	1000 V CAT II
Dimensions
Length	102 mm
Width	9 mm
Collar width	16 mm
Tip
Diameter	0.6 mm
Total length	45 mm
Unisolated length	18 mm
Weight	5.8 g
Color	green, blue, yellow, red or black